Owner manual

QUICK SETUP

To start using the MULTIAMP MIDI PEDALBOARD, use a 5 pin MIDI connector.

Plug one end into the MIDI OUT jack of the MULTIAMP MIDI PEDALBOARD and plug the other end into the MIDI IN jack of the Multiamp (or

other MIDI receiving device). The Multiamp provides phantom power, so the pedalboard is directly powered; for other MIDI devices that don’t

provide that, you will need to use a 9V power supply connected to the DC IN.

Now assign the MULTIAMP MIDI PEDALBOARD’s MIDI

channel to the same MIDI channel of the Multiamp (or other

device that is receiving MIDI). Press the Menu button of

the pedalboard so that a “Chl” message will appear on the

display, now press OK and the MIDI channel number will

appear (by default both Multiamp and MULTIAMP MIDI

PEDALBOARD are setted on channel “00”); to change the

MIDI channel to match a receiving device’s MIDI channel

use the 8 and 4 buttons to scroll UP and DOWN “MIDI

Channels”, then press OK to store and ESC to return to

the program change (PC) function.

5 6 87

1 2 43

MIDI PEDALBOARD

CC0 CC1 CC2 CC3

CC4 CC5 CC6 CC7

HOLD 2 sec for 2nd FN

ESC OK MENU

PC/CC

TUNER

TAP

MULTIAMP

DC IN

USB

MIDI OUTEXP PEDAL