Specifications

1.0 INSTALLATION DETAILS

This water heater must be installed by a licensed tradesperson, and in

accordance with:

• AS/NZS3500.4.2 “National Plumbing and Drainage Code Hot Water Supply

Systems – Acceptable Solutions” .

• Local authority regulations.

• Outside Australia and New Zealand, please refer to local plumbing and

building codes and regulations.

• Notice to Victorian customers from the Victorian Plumbing Industry

Commission – this water heater must be installed by a licensed person as

required by the Victorian Building Act 1993. Only a licensed person will give

you a compliance certificate, showing that the work complies with all the

relevant Standards and only a licensed person will have insurance

protecting their workmanship for 6 years.

NOTE: This water heater and heat pump components are not suitable

for pool heating.

All warranty is voided if the unit is laid on its side for storage or

transport. It must be stored and transported in a near vertical position

at all times, there are no exceptions.

This water heater is designed for direct connection to water supply pressures

of no greater than:

• 250 Litre Model - 1000kPa

Where the mains pressure can exceed or fluctuate beyond the pressure

shown above a pressure limiting device (complying with AS1357) must be

fitted in the cold water inlet supply. This device must be installed after the

isolating valve and set at or below the pressure shown above. Note during

periods of lower demand water pressure may increase.

CAUTION: This water heater delivers hot water at temperatures

exceeding 50

C. Refer to AS/NZS3500 and local regulations regarding

the need for additional temperature control of hot water delivery.

LOCATION

The water heater should be located as close as possible to the most

frequently used hot water outlet. Ensure that the data plate is clearly visible

and provide adequate access for service to the element, thermostat, relief

valve and anode.

Part No: H3023 4 of 22

Version: 10155A