Update Description
Table Of Contents
- DSM-04D(MG24) Zigbee Cloud Module Datasheet-V1.0_20221121
- 1Introduction
- 2Mechanical Requirement
- 3Electrical parameters
- 4RF features
- 4.1Basic RF feature
- 4.2RF Transmitter Characteristics
- 4.2.1RF Transmitter General Characteristics for the 2.4
- 4.2.2RF Transmitter Characteristics for 802.15.4 DSSS-O
- 4.2.3RF Transmitter Characteristics for Bluetooth Low E
- 4.2.4RF Transmitter Characteristics for Bluetooth Low E
- 4.2.5RF Transmitter Characteristics for Bluetooth Low E
- 4.2.6RF Transmitter Characteristics for Bluetooth Low E
- 4.3RF Receiver Characteristics
- 4.3.1RF Receiver General Characteristics for the 2.4 GH
- 4.3.2RF Receiver Characteristics for 802.15.4 DSSS-OQPS
- 4.3.3RF Receiver Characteristics for Bluetooth Low Ener
- 4.3.4RF Receiver Characteristics for Bluetooth Low Ener
- 4.3.5RF Receiver Characteristics for Bluetooth Low Ener
- 4.3.6RF Receiver Characteristics for Bluetooth Low Ener
- 5Antenna
- 6Production instructions
- 7Recommended oven temperature curve
- 8Storage conditions
- 9Ordering information
- 10MOQ and packing
- FCC with modular Statement
浙江东胜物联技术有限公司
Zhejiang Dusun Electron Co., Ltd.
杭州市大关路 189 号万通中心 A 幢 8 楼 Floor 8, Building A, Wantong Center
Tel: 86-571-86769027/8 8810480 Hangzhou, China
Website: www.dusuniot www.dusunremotes.com www.dusunlock.com
Spurious emissions out-of-band
in non-restricted bands per FCC
Part 15.247
Frequencies above 2.483GHz or below
2.4GHz,continuous transmission CW carrier,
Pout=POUTMAX, Test Frequency=2450 MHz
-
-26
-
dBm
Spurious emissions per
ETSIEN300.440
47-74 MHz,87.5-108 MHz,174-230 MHz,
470-862 MHz, Pout= 10 dBm, Test Frequency
= 2450MHz
-
-60
-
dBm
25-1000 MHz, excluding above frequencies.
Pout = 10 dBm, Test Frequency = 2450 MHz
-
-42
-
dBm
1G-14G, P
out
= 10 dBm, Test Frequency =
2450 MHz
-
-36
-
dBm
Spurious emissions out-of-band,
per ETSI 300.328
[2400-2BW to 2400-BW],[2483.5+BW to
2483.5+2BW],P
out
= 10 dBm, Test Frequency
=2450 MHz
-
-26
-
dBm
47-74 MHz, 87.5-118 MHz,174-230 MHz,
470-862 MHz, Pout= 10 dBm, Test Frequency
= 2450MHz
-
-60
-
dBm
30-47 MHz, 74-87.5 MHz,118-174 MHz,
230-470MHz,862-1000 MHz ,
Pout=10dBm,Test Frequency=2450 MHz
-
-42
-
dBm
1G-12.75 GHz, excluding bands listed above,
Pout=10dBm, Test Frequency = 2450 MHz
-
-36
-
dBm
[2400-BW to 2400], [2483.5 to2483.5+BW]
Pout=10dBm, Test Frequency=2450 MHz
-
-16
-
dBm
Frequency error
-15
-
15
ppm
Note:
1. Supply current to radio, supplied by DC-DC with 3.0 V, measured at VREGVDD.
2. Supported transmit power levels are determined by the ordering part number (OPN). Transmit power ratings for all
devices covered in this data sheet can be found in the Max TX Power column of the Ordering Information Table.
3. The PA is capable of delivering higher than 10 dBm output power (refer to Output Power plots in 4.27.2 RF
Characteristics). How-ever, all transmitter characteristics and recommended application circuits are specified at 10
dBm output. If used with the recommended application circuits above 10 dBm, harmonics may be higher than
regulatory limits.
4.2.2 RF Transmitter Characteristics for 802.15.4 DSSS-OQPSK in the 2.4 GHz Band
Parameter
Test Condition
Min.
Typ.
Max.
Unit
Error vector magnitude
per802.15.4-2011(EVM)
Average across frequency, signal is
DSSS-OQPSK reference pack-et,
PAVDD=3.3 V, Pout=POUTMAX
-
-3
-
% rms
Power spectral density limit
Relative, at carrier ±3.5MHz,PAVDD=3.3V,
Pout=POUT
MAX
-
-50.2
-
dBc/100k
Hz
Occupied channel bandwidth
per ETSI EN300.328
99% BW at highest and lowest channels in
band, Pout=10dBm
-
2.2
-
MHz










