User Manual

6
Question Answer
Why is so much dust going into
the lter housing?
Tank is full and needs to be emptied.
Bag has sucked up into cyclone, x it.
Bag is not in tank & tank has a leak, plug leak.
Cyclone seal needs to be xed.
Why is the Bag sucking up
into the cyclone?
Attach equalizer hose to tank port
Remove air between tank & bag before adding cyclone lid
Bag is not thick enough and needs replaced with a 6 mil bag
Tank has an air leak, plug leak
Equalizer hose is plugged or has a hole
Suction is low Clean the lters.
Check for blockages in hoses and cyclone.
Inspect seals on door and lids, and hoses for holes and leaks.
Motor has improper voltage or has stopped, check voltage
& motors
Dust collection inadequate even
though vacuum is good
Check the machine shroud for leaks and proper clearance
between the shroud and work surface (tighter to surface is
generally better).
Motor is not running Check that vacuum is plugged in and has correct power
Circuit breaker has tripped and needs to be reset.
Brushes are consumed and need to be replaced.
Power switch or motor has gone bad, check them.
Vacuum is blowing dust Filter has not sealed properly and needs to be reseated.
Dust is inside the tank coming through the equalization hose
because the bag is not in place or has holes in it.
Frequently Asked Questions