OWNERS MANUAL D16 Series 16 Series dustlesstools.com PATENT NO.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANTES MESURES DE SECURITE SAVE THESE INSTRUCTIONS IMPORTANTE PARA SU SEGURIDAD CONSERVER CES INSTRUCTIONS GUARDAR ESTAS INSTRUCCIONES NOTE: The reading and understanding of the Owner’s Manual is imperative prior to operating this machine. If you or your operator(s) cannot read English, have this manual explained fully before attempting to operate this machine. Si Ud.
IN THE BOX D1603 16 GAL WET+DRY DUSTLESSVAC WITH 12 FT.
D1608 RENOVATE RIGHT EPA HEPA KIT: DustBuddie ChipBuddie HEPA Floor Tool + 18” Hose Adapter 16250 SHERWIN WILLIAMS HEPA RRP KIT: HEPA Floor Tool + Adapter 16500 DUSTLESS EPA LEAD SAFE COMPLIANCE: Dustie ChipBuddie 6’ Hose HEPA Floor Tool + #32 Clamp Adapter Zip Tie D1607 HEPA - 240V 16 GAL WET+DRY VAC: HEPA Filter Extension Wands Crevice Tool Floor Tool Lid Filter Cover WunderBag Hose 4 10” Clamp Barrel Customer Service Helpline 1.800.568.3949 dustlesstools.
SETUP 1. Remove entire contents of box. WUNDERBAG INSTALLATION 1. Place the cardboard collar with the rubber gasket securely over the intake port on the inside of the barrel. 2. Slide legs into slots with the legs with the hooks in the back. Screw in screws. 2. Reach inside the port and with your fingers press cardboard tight and secure around port. 3. Attach tool tray. 4. Place intermediate on barrel. Use clips to secure in place. USAGE DRY PICKUP 1. Barrel should be emptied of any wet waste.
vacuum and disconnect from outlet. Note: When barrel is full the automatic shut-off mechanism will shut off vacuum pickup. When this happens, the motor will become noticeably higher pitch. CHANGING WUNDERBAGS 1. Disconnect the vacuum from outlet. 2. Remove intermediate. 4. Empty barrel by unscrewing drain cap. Drain is regulated so liquid can go from a drip to a full flow. Note: Hose can be put in the drain cap to drain up to 12 feet away. CLEAN FILTERS (REGULAR WET+DRY) 1.
required. To determine ampere rating of your vacuum, refer to nameplate located on rear of motor cover. Before using appliance, inspect power cord for loose or exposed wires and damaged insulation. Make any needed repairs or replacements before using your appliance. Use only three-wire outdoor extension cords which have threeprong grounding-type plugs and three-pole receptacles which accept the extension cords plug.
2. Place the HEPA filter cover support on the HEPA filter. FAQ QUESTION 3. Place the HEPA filter cover over the HEPA filter cover support and HEPA filter. Place the 10” hose clamp over the HEPA filter cover so it rests on the metal ring of the filter. Tighten the clamp with a screw driver. ANSWER Why is the vacuum blowing dust? • Check filter(s) for holes and that they are securely in place. • WunderBag may not be securely in place. Why have I lost suction? • The drain cap may be open.
