User Manual

6
Customer Service Helpline 1.800.568.3949 dustlesstools.com
SETUP
1. Remove entire contents of box.
2. Slide legs into slots with the legs with the
hooks in the back. Screw in screws.
3. Attach tool tray.
4. Place intermediate on barrel. Line
Clamps up with the raised portion of the
intermediate and secure in place.
5. Slide one end of the hose into the port.
Slide desired attachments on to the other
end of the hose.
WUNDERBAG INSTALLATION
1. Place the cardboard collar with the rubber
gasket securely over the intake port on the
inside of the barrel.
2. Reach inside the port and with your ngers
press cardboard tight and secure around
port.
WET PICKUP
1. Vacuum should be emptied of any dry
waste. Motor lters must remain in place.
Note: Should lters become wet, dry both
lters thoroughly before continued use.
WunderBag can remain in place when
collecting small amounts of water but should
be removed when collecting large amounts.
2. Connect hose and desired attachment.
3. After use or when barrel is full turn off
vacuum and disconnect from outlet.
Note: When barrel is full the automatic shut-
off mechanism will shut off vacuum pickup.
When this happens, the motor will become
noticeably higher pitch.
4. Empty barrel after each use by unscrewing
drain cap. Drain is regulated so liquid can
go from a drip to a full ow. Note: Hose can
be put in the drain cap to drain up to 12 feet
away.