User's Manual

PRELIMINARY Confidential
M2x40 Mote Datasheet Dust Networks™ 4
1.0 Absolute Maximum Ratings
The absolute maximum ratings shown below should under no circumstances be violated. Permanent damage to the device
may be caused by exceeding one or more of these parameters.
Table 1 Absolute Maximum Ratings
Parameter Min Typ Max Units Comments
Supply voltage (Vcc to GND) –0.3 3.6 V
Voltage on any digital I/O pin –0.3 V
CC
+ 0.3
up to 3.6
V
Input RF level 10 dBm
Input power at antenna
connector
Storage temperature range –45 +85 °C
Lead temperature +230 °C For 10 seconds
VSWR of antenna 3:1
* All voltages are referenced to GND
Caution! The M2x40 can withstand an electrostatic discharge of up to 2 kV Human Body Model (HBM) or
200 V Machine Model (MM) applied to any header pin, except the antenna connector. The antenna input can
withstand a discharge of up to 50 V.
2.0 Normal Operating Conditions
Table 2 Normal Operating Conditions
Parameter Min Typ Max Units Comments
Operational supply voltage
range (between Vcc and GND)
2.75 3.3 V
Including noise and load
regulation
Voltage on analog input pins 0 1.8 V
Voltage supply noise 200 mV
p-p
50 Hz–15 MHz
Peak current
Power amplifier enabled TBD mA
TX during OTAP*. (TBD)
ms max
TBD mA TX, 5 ms maximum
TBD mA
Searching for network, 60
minutes maximum
TBD mA
Radio turn on, (TBD) μs
max
TBD mA boot_delay (see Table 7)
Peak current
Power amplifier disabled TBD mA
TX during OTAP*. (TBD)
ms max
TBD mA TX, 5 ms maximum
TBD mA
Searching for network, 60
minutes maximum
TBD mA
Radio turn on, (TBD) μs
max
TBD mA boot_delay (see Table 7)
Average current