User's Manual

PRELIMINARY Confidential
M2x40 Mote Datasheet Dust Networks™ 16
Figure 12 M2x40 Mote Footprint
9.2 Soldering Information
The M2x40 can be hand soldered with a soldering iron at 230 °C. The soldering iron should be in contact with the pin for 10
seconds or less. The M2x40 is also suitable for eutectic PbSn reflow.
10.0 Regulatory and Standards Compliance
10.1 FCC Compliance
The M2x40 mote complies with Part 15.247 modular (Intentional Radiator) of the FCC rules and regulations. Changes or
modifications not expressly approved by Dust Networks could void the user's authority to operate the equipment.
10.1.1 FCC Testing
In order to fulfill FCC certification requirements, products incorporating the M2x40 mote must comply with the following:
1. An external label must be provided on the outside of the final product enclosure specifying the FCC identifier as
described in 10.1.3 below.
2. The antenna must be electrically identical to the FCC-approved antenna specifications for the M2x40 as described in
10.1.2 with the exception that the gain may be lower than specified in Table 14.
3. The device integrating the M2x40 mote may not cause harmful interference, and must accept any interference received,
including interference that may cause undesired operation.