User's Manual
Table Of Contents
- 1.0 Absolute Maximum Ratings
- 2.0 Normal Operating Conditions
- 3.0 Electrical Specifications
- 4.0 Radio
- 5.0 Pinout
- 6.0 Mote Boot Up
- 7.0 Interfaces
- 7.1 Status LED Signal
- 7.2 Discrete Input/Output (I/O)
- 7.3 Deep Sleep
- 7.4 Serial Interface
- 7.4.1 Serial Flow Control
- 7.4.2 Mote Command Data Types
- 7.4.3 Mote Commands
- 7.4.3.1 Command 0x80 Serial Payload Sent to Mote Serial
- 7.4.3.2 Command 0x81 Unacknowledged Serial Payload Received from Mote Serial
- 7.4.3.3 Command 0x82 Acknowledged Serial Payload Received from Mote Serial
- 7.4.3.4 Command 0x84 Time/State Packet
- 7.4.3.5 Commands 0x87 and 0x88 Set Parameter Request/Response
- 7.4.3.6 Commands 0x89 and 0x8A Get Parameter Request/Response
- 7.4.3.7 Command 0x8C Mote Information
- 7.4.3.8 Command 0x8D Reset Mote
- 7.4.4 Mote Get/Set Command Parameters
- 7.4.5 HDLC Packet Processing Examples
- 8.0 Packaging Description
- 9.0 Regulatory and Standards Compliance
- 10.0 Ordering Information
Pinout
8 DUST NETWORKS™ M1030-2 MOTE DATASHEET
CONFIDENTIAL
5.0 Pinout
The M1030-2 has two 11-pin Samtec MTMM-111-04-S-S-175-3 (or equivalent) connectors on the bottom side for handling all
of the I/O. The third pin in each of the connectors is not populated, and serves as a key for alignment. The connectors are
mounted on opposite edges of the long axis of the M1030-2.
The M1030-2 serial interface (serial protocol is specified in 7.4.1) provides flow control in the receive direction only.
The RST input pin is internally pulled up, and is optional. When driven active low, the mote is hardware reset until the signal
is deasserted. Refer to section
6.1 for timing requirements on the RST pin. Note that the mote may also be reset using the mote
serial command (see section 7.4.3.8 ).
Table 9 M1030-2 Pin Functions
Pin
Number Name
Mote I/O
Direction
Internal Pull Up/
Down
1 GND In None
2 VCC In None
3 KEY (no pin) - None
4 RX In None
5 TX Out None
6 LED Out None
7 A1 In None
8 CTS Out None
9 D1 Out None
10 D2 In None
11 A2 In None
12 VRef Out None
13 No Connection - None
14 No Connection - None
15 No Connection - None
16 No Connection - None
17 No Connection - None
18 No Connection - None
19 No Connection - None
20 KEY (no pin) - None
21 No Connection - None
22 RST In
100 kΩ pull up
Figure 3 M1030-2 Package with Pin Labels