User's Manual
Table Of Contents
- 1.0 Absolute Maximum Ratings
- 2.0 Normal Operating Conditions
- 3.0 Electrical Specifications
- 4.0 Radio
- 5.0 Pinout
- 6.0 Mote Boot Up
- 7.0 Interfaces
- 7.1 Status LED Signal
- 7.2 Discrete Input/Output (I/O)
- 7.3 Deep Sleep
- 7.4 Serial Interface
- 7.4.1 Serial Flow Control
- 7.4.2 Mote Command Data Types
- 7.4.3 Mote Commands
- 7.4.3.1 Command 0x80 Serial Payload Sent to Mote Serial
- 7.4.3.2 Command 0x81 Unacknowledged Serial Payload Received from Mote Serial
- 7.4.3.3 Command 0x82 Acknowledged Serial Payload Received from Mote Serial
- 7.4.3.4 Command 0x84 Time/State Packet
- 7.4.3.5 Commands 0x87 and 0x88 Set Parameter Request/Response
- 7.4.3.6 Commands 0x89 and 0x8A Get Parameter Request/Response
- 7.4.3.7 Command 0x8C Mote Information
- 7.4.3.8 Command 0x8D Reset Mote
- 7.4.4 Mote Get/Set Command Parameters
- 7.4.5 HDLC Packet Processing Examples
- 8.0 Packaging Description
- 9.0 Regulatory and Standards Compliance
- 10.0 Ordering Information
Absolute Maximum Ratings
4 DUST NETWORKS™ M1030-2 MOTE DATASHEET
CONFIDENTIAL
1.0 Absolute Maximum Ratings
The absolute maximum ratings shown below should under no circumstances be violated. Permanent damage to the device may
be caused by exceeding one or more of these parameters.
The M1030-2 can withstand an electrostatic discharge of up to 2 kV Human Body Model (HBM) or 200 V
Machine Model (MM) applied to any header pin, except the antenna connector. The antenna input can withstand a
discharge of 50 V.
2.0 Normal Operating Conditions
Unless otherwise noted, Table 3 assumes Vcc is 3.0 V.
Table 1 Absolute Maximum Ratings
Parameter Min Typ Max Units Comments
Supply voltage (Vcc to GND) –0.3 3.6 V
Voltage on digital I/O pin –0.3 V
CC
+ 0.3
up to 3.6
V
Input RF level 10 dBm Input power at antenna
connector
Storage temperature range –45 +85 °C
Lead temperature +230 °C For 10 seconds
VSWR of antenna 3:1
* All voltages are referenced to GND
Table 2 Normal Operating Conditions
Parameter Min Typ Max Units Comments
Operational supply voltage range
(between Vcc and GND)
2.7 3.3 V Including noise and load
regulation
Voltage on analog input pins 0 1.5 V
Voltage supply noise 10 mVp-p 50 Hz–2 GHz
Peak current 40
18
mA
mA
Tx, 14 ms maximum
Rx, searching for
network, 60 minutes,
maximum
Average current 30
μA
Assuming 80-byte
packets, 1 per minute,
data only mote, 3 V,
25
°C
Storage and operating temperatures –40 +85 °C
Maximum allowed temperature ramp 8 °C/min –40 °C to +85 °C
Table 3 Current Consumption
Parameter Min Typ Max Units Comments
Transmit 28 40 mA
Receive 14 18 mA
Sleep 8 18 μA