User's Manual

Advanced Information
LM2610 User’s Guide Dust Networks™ 3
1.0 Absolute Maximum Ratings
The absolute maximum ratings shown below should not be violated under any circumstances. Permanent damage to the
device may be caused by exceeding one or more of these parameters.
Table 1 Absolute Maximum Ratings
Parameter Min Typ Max Units Comments
Supply voltage –0.3 3.6 V
Voltage on Input Pins –0.3 3.6 V
Input RF level 10 dBm
Input power at antenna
connector
Storage temperature range –40 +85 °C
VSWR of antenna 3:1
ESD protection
Antenna connector ±250 V HBM
All other connectors ±TBD kV HBM
±TBD V CDM
All voltages are referenced to V
SS
Caution! This is an ESD sensitive device. Use proper ESD handling procedures when working with the device to prevent
permanent damage.
2.0 Normal Operating Conditions
Table 2 Normal Operating Conditions
Parameter Min Typ Max Units Comments
Operational supply voltage
range (between V
DD
and V
SS
)
3.0 3.3 3.6 V
This includes noise and
load regulation. During
power on, it is essential
that the maximum V
DD
rise time defined in
section Error! Reference
source not found. is
met.
Voltage supply noise 100 mV
p-p
50 Hz–50 MHz
Peak current TBD mA
Average current TBD mA +3.3V, 25 °C
Operating temperature range –40 +85 °C
Maximum allowed temperature
ramp during operation
8 °C/min –40 °C to +85 °C
Operating relative humidity 10 95
% RH
Non-condensing
The specifications listed are for the power supply connected to V
DD
and V
SS
and apply over the operating
temperature range unless otherwise specified.
3.0 Electrical Specifications
I/O specifications are given below for each I/O level type given in the board-to-board connector tables in sections 4.1 and
4.2.1. Unless otherwise noted, supply voltage is 3.3 V and temperature range is –40 °C to +85 °C.