User's Manual

Advanced Information
12 Dust Networks™ LM2610 User’s Guide
6.1.2 FCC-approved Antennas
The following are FCC-approved antenna specifications for the LM2610.
Table 12 FCC-approved Antenna Specifications for the LM2610
Gain Pattern Polarization Frequency Connector
+2 dBi maximum Omnidirectional Vertical 2.4–2.4835 GHz MMCX
6.1.3 OEM Labeling Requirements
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. The outside of the final
product enclosure must have a label with the following (or similar) text specifying the FCC identifier. The FCC ID and
certification code must be in Latin letters and Arabic numbers and visible without magnification.
Contains transmitter module FCC ID: SJC-LM2610
or
Contains FCC ID: SJC-LM2610
6.2 IC Compliance
6.2.1 IC Testing
The LM2610 will be certified for modular Industry Canada (IC) RSS-210 approval. The OEM is responsible for its product
to comply with IC ICES-003 and FCC Part 15, Sub. B - Unintentional Radiators. The requirements of ICES-003 are
equivalent to FCC Part 15 Sub. B and Industry Canada accepts FCC test reports or CISPR 22 test reports for compliance with
ICES-003.
6.2.2 IC-approved Antennas
The LM2610 has been designed to operate with the antenna characteristics shown in Table 13. Antennas not included in this
list or having a gain greater than shown in Table 13 are strictly prohibited for use with this device. The required antenna
impedance is 50 Ohms. To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Table 13 IC-approved Antenna Specifications for the LM2610
Gain Pattern Polarization Frequency Connector
+2 dBi maximum Omnidirectional Vertical 2.4–2.4835 GHz MMCX
6.2.3 OEM Labeling Requirements
The Original Equipment Manufacturer (OEM) must ensure that IC labeling requirements are met. The outside of the final
product enclosure must have a label with the following (or similar) text specifying the IC identifier. The IC ID and
certification code must be in Latin letters and Arabic numbers and visible without magnification.
Contains IC: 5853-LM2610