User's Manual

Advanced Information
LM2610 User’s Guide Dust Networks™ 11
Figure 4 LM2610 (Side and Bottom)
6.0 Regulatory and Standards Compliance
6.1 FCC Compliance
6.1.1 FCC Testing
The LM2610 Embedded Manager will be tested for compliance with Part 15.247 modular (Intentional Radiator) of the FCC
rules and regulations. In order to fulfill FCC certification requirements, products incorporating the LM2610 Embedded
Manager must comply with the following:
1. An external label must be provided on the outside of the final product enclosure specifying the FCC identifier, as
described in section 6.1.3 below.
2. The antenna must be electrically identical to the FCC-approved antenna specifications for the LM2610 as described in
6.1.2, with the exception that the gain may be lower than specified in Table 12.
3. The device integrating the LM2610 may not cause harmful interference, and must accept any interference received,
including interference that may cause undesired operation.
4. An unintentional radiator scan must be performed on the device integrating the LM2610 Embedded Manager, per FCC
rules and regulations, CFR Title 47, Part 15, Subpart B. See FCC rules for specifics on requirements for declaration of
conformity.
Any changes or modifications to the LM2610 not expressly approved by the party responsible for compliance could void the
authority to operate the equipment.
.