Full Product Manual

7
INSTALLATION
2 Installation of Generator Set
2.1 Outdoor Operation
Choose a location where the generator will not be exposed to rain, snow, or
direct sunlight. Position the generator on a secure and level ground so it will
not tip or slide down on a hill. Place the generator so that the exhaust fumes
will not be directed towards anyone.
The installation site must be free from water, moisture, or dust. All electrical
components should be protected from excessive moisture or the insulation
system will deteriorate and result in grounding or will short out the generating
system.
Foreign matter, such as dust, dirt, sand, lint, or abrasive materials can cause
damage to the generator and engine and are not allowed into its cooling
system.
2.2 Generator Set Grounding
The generator is equipped with grounding terminal
located on the rear of the opening type and at the low
position of back side of the silent type (refer to figure 2-1).
Ground the generator by tightening the grounding nut
against a grounding wire. A generally acceptable
grounding wire is a No. 12 AWG (American Wire Gauge)
stranded copper wire. This grounding wire should be
connected at the other end to a copper or
brass-grounding rod that is driven into the end.
Grounding codes can vary by location. Please contact a
local electrician to check the grounding regulations for your area.
WARNING:
Failure to properly ground the generator can result in electrocution.
WARNING
Always use electrical cords that are in good condition. Worn, bare, frayed or
other damaged cords can cause electric shock.
Before operation, the generator should be grounded to prevent electric shock.
Contact a licensed electrician to wire electrical plugs and/or cord sets.
Improper wiring could result in a fire or electrical shock.
DANGER
Never use your generator inside enclose areas or indoors. Engines consume
oxygen and give off deadly carbon monoxide poisonous gas. Improper
ventilation will cause damage to generator and injury to people.