Full Product Manual

21
MAINTENANCE / INSPECTION / REPAIR /
TROUBLESHOOTING
8.1.9 Check and replenish electrolytes of
battery and charge.
This generator set uses a 12V battery. The
electrolyte of the accumulator will be lost
through continuous charging and discharging.
Before starting, check the battery for any
damage and that its electrolyte level is
normal. If necessary, replenish distilled water
in it. If damaged, replace the battery.
Check electrolyte of battery:
Once a month
Voltage of battery:
12V-14V
8.2 Maintenance for long time storage.
If your generator should be stored for a long
period, the following preparation should be
done:
8.2.1 Operate the generator set for about
15 minutes.
8.2.2 Stop the diesel engine. When the
diesel engine is still hot, drain the old lube
oil out and fill new oil.
8.2.3 Pull out the screw plug on the cover
of the cylinder head and fill 2 ml of lube
oil. Screw the plug tightly on its original
position.
8.2.4 Maintenance of starting position.
(1) Recoil starting:
Set the fuel cock to “OFF” position. Press the
decompression lever down and pull the recoil
handle 2 or 3 times. (Do not start the diesel
engine).
(2) Electric starting:
Set the fuel cock to “OFF” position. Start the
diesel engine about 2-3 seconds. Do not start
the diesel engine.
8.2.5 Pull the decompression lever out and
pull the recoil starter slowly. When you feel, it
fastening, stop? (The intake and drain valve is
closed. It helps prevent rust.)
8.2.6 Clean and store in dry area.
9 Inspection, repair, and trouble shooting.
9.1 Doubtful points and problems
If you have any questions or problems during
operation, please contact the dealer. You will
need to provide the following information.
(1) The type, model and serial number of the
diesel generator set.
The cylinder block oil draining bolt locates the
serial number and type. Type and
manufacturing date is located on the name
plate.
The model number of the diesel generator set
is located on the chassis of the framework for
opening type. For the silent type, it is located
on the foundation beside the battery.
(2) Status
What problem occurred when you operated
the generator set and at what speed?
(3) How long was your unit operated?
(4) Operation conditions and time?
For more detailed information, please fill out
an opinion form and mail it to your dealer.
9.2 Inspection, repair and troubleshooting
If electricity cannot be generated after the
generator has been serviced following the
chart of troubleshooting (next page), please
contact your dealer directly.