Replacement Part List

Owner’s Manual

- 16 -

SERVICE POINTS

a. Cylinder fins

Dust clogging between the cylinder fins will cause over

heating of the engine. Periodically check and clean the

cylinder fins after removing the air cleaner and the

cylinder cover.

Be sure to block the air intake hole.

b. Fuel filter

a. Using a wire hook, take out the filter from the

filler port.

b. Disassemble the filter and wash with gasoline.

(1) Fuel filter

After removing the filter, use a pinch to hold the end of the suction pipe, take

care not to allow filters or d

ust inside the suction pipe.

c. Oil tank

With a wire hook, take out the oil filter through the filler

port and clean in

gasoline. When putting the filter back into the tank, make sure that it comes to

the front right corner. Also, clean off dirt in the tank.

d. Spark plug

Clean the electrodes with a wire brush and reset

the gap to 0.6~0.7 mm as necessary.

e. Sprocket

Check for cracks and for excessive wear interfering with the chain drive. If the

wearing is found obv

iously. Replace it with new one. Never fit a new chain on

worn sprocket, or a worn chain on a new sprocket.

Note

Cylinder fins