Replacement Part List

Owner’s Manual
- 11 -
Starting the engine
1. Fill fuel and chain oil tanks respectively and tighten
the caps securely.
2. Put the switch to “I” position.
3. Push the choke knob upward. The choke will close
and the throttle lever will then be set in the starting
position.
When restarting immediately after stopping the engine,
leave the choke knob at the open position.
Do not start the engine while holding the chainsaw.
The saw chain may touch your body. It’s very
dangerous.
4. After all the pr
eparations, pull the starter again to start
the engine.
5. When the engine start open the choke and allow the
engine to warm up for 3 minutes.
Keep clear of the saw chain as it will start rotating
upon starting of engine.
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in
the figure.
(1) Chain oil
⑴
Chain oil
⑵ Fuel
⑶ Switch
⑷ throttle lever
⑸ Throttle interlock
⑹ Choke knob
Note
△
！
Warning
△
！
Warning
（
6
）
（2）
（
1
）
7. OPERATING