Use and Care Manual

21
GENERATOR ASSEMBLY AND MOUNTING
The Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please
follow the instructions below. If you not use the wheel kit, please skip this section.
1. Place the bottom of the generator on a flat, even surface. You may temporarily place the
generator on blocks to ease assembly.
2. Attach the support leg to the cradle with bolts (M8x 16) and tighten nuts (M8) (see figure 1 ).
3. Attach the axles to the frame and tighten nuts (M12) (see figure 2).
4. Slide a wheel, hub to the inside, and a flat washer over the axle, then fix the wheel tightly with
a retaining pin (see figure 3, Figure 4).
5. Place the handles on the cradle tightly with bolts (M8x16) and tighten nuts (M8) gently.
Overtightening the handles will cause them to be very difficult to move. (Figure 5, Figure 6).
6. Make sure that all fasteners are tight and tight and tires are inflated between 15-40 PSI.
Figure 1
Figure 2
Figure 3
Figure 4 Figure 5 Figure 6