Specification

800 USG.4YOU
800 (874-4968)
usg.com
Manufactured for
United States Gypsum Company
550 West Adams Street
Chicago, IL 60661
CB666/2-14
© 2014 USG Corporation and/or
its aliates. All rights reserved.
Printed in U.S.A.
Appearance Smooth
Color White
Specific gravity 1.50
Extrusion rate (g/minute) 200
Slump (in) 0
Skin-over time (minute) 8
Tack-free time (minute) 45
Shore “A” 50
Tensile strength (psi) 325
Elongation (%) 275
Modulus (psi) 300
Solid (%) 98
VOC Content g/L 15
TECHNICAL INFORMATION
Product InformatIon
See usg.com for the most up-to-date product information.
WarnIng
DIRECT CONTACT OF UNCURED SEALANT IRRITATES EYES
AND MAY IRRITATE SKIN. Use proper personal protective
equipment; safety glasses to protect eyes and rubber
gloves to protect hands. OVEREXPOSURE TO VAPOR MAY
IRRITATE EYES, NOSE AND THROAT. Avoid eye and skin
contact. Use with adequate ventilation. Do not handle
contact lenses with sealant on hands. IN CASE OF EYE
CONTACT, flush eyes with water for 15 minutes. Obtain
medical attention. IN CASE OF SKIN CONTACT, remove
from skin and flush with water. KEEP OUT OF REACH
OF CHILDREN. For safe handling information consult
the Material Safety Data Sheet (MSDS). Product safety
information: CHEMTREC [phone] (24 hours) or
accumetricinc.com
trademarks
The trademarks USG, DUROCK, IT'S YOUR WORLD. BUILD IT.,
THE USG LOGO, and related marks are trademarks of USG
Corporation or its aliates.
note
Products described here may not be available in all
geographic markets. Consult your USG sales oce or
representative for information.
notIce
We shall not be liable for incidental and consequential
damages, directly or indirectly sustained, nor for any loss
caused by application of these goods not in accordance with
current printed instructions or for other than the intended
use. Our liability is expressly limited to replacement of
defective goods. Any claim shall be deemed waived unless
made in writing to us within thirty (30) days from date it
was or reasonably should have been discovered.
safety fIrst!
Follow good safety/industrial hygiene practices during
installation. Wear appropriate personal protective
equipment. Read MSDS and literature before specification
and installation.