Operation Manual

2.2 Elements at the stand

Elements function

Main switch 2 – Turning on and off the machine.

Pedal 3

Idle position

– No function.

Position "half back"

– Lifting the foot at machine standstill.

Position "completely

back"

– Activating the thread trimmer and lifting the foot.

Positions "in front"

– Sewing at the desired speed.

Knee switch 1 – This key has the same function as the key 14

(page 9) of the key block:

Activating a higher foot stroke.

– The operating mode

"Activation as long as the key is being operated"

"Activation until the key is being re-operated"

"Activation as long as the key is being operated and

until all input stitches are sewn"

depends on the input at the control panel.

Maintenance unit

Air filter and water

separator 8

– Before the water level reaches the filter, turn in the

drain screw 7 accordingly. While doing so, do not

interrupt the supply of compressed air.

Pressure regulator 9 – To adjust 6 bar pull up the sleeve 10 and turn it

accordingly.

Mist lubricator 6 – Adjust approx. 1 drop for 10 work cycles using the

set screw 4.

To refill, vent the pneumatic system, turn out the

screw 5 and refill the oil ESSO "SP NK 10" up to the

"groove".