Technical information

Update of the controle

DACeco

8 Update of the controle

You can update the controle software and the default parameter of the machine.

You need a memory dongle (9835 901005) with the controle software to update the controle.

You can find the software on the homepage of Dürkopp Adler.

8.1 Update process

Connect all plugs of the machine head with the control. It is very important that the machine ID is connected with the

control.

Der Speicher-Dongle mit der Steuerungssoftware muss an die Pedal-Schnittstelle angeschlossen werden.

Insert a DA-Dongle with the control software at the connector of the foot pedal.

Machine-ID

Switch on the control. Both LEDs will be flashing

That’s means that the software will be updated. If the the update was successfully you can hear a signal and the lowest

LED will be flashing. The LEDs (Power und Message) are activated.