Technical information

Setting the basic functions

DACeco

7.5 Machine selection

If the programming level of a parameter is selected, buttons S1 and S2 have the following functions:

Cancellation - Keep S2 ( ESC) pressed (> one second)

Plus - Briefly press S1 (+) (< one second)

Minus - Briefly press S2 (-) (< one second)

Select the next parameter set by briefly pressing S1. Select the previous parameter set by briefly pressing S2.

The set value is then indicated by the flashing LEDs.

LED1 : 10s digit

LED1 : 1s digit

The LEDs flash every 0.5 seconds. After a pause of 1.5 seconds, the sequence is repeated until it is confirmed or

cancelled.

Confirm the programmed result by pressing S1. Leave the programming level by pressing S2.

In order to load a new parameter set, insert a DA dongle with parameter sets in the pedal interface.

You can find this software on the homepage of Dürkopp Adler.

You can find a list with the machine classes in the additional txt-file.

Example:

The following machine classes could select:

1. 171-131610

2. 173-141610

3. 271-140342-01

4. 272-140342-01

5. 281-140342-01

6. 838-x70522-M

7. 867-190x22-M

8. 867-190x42-M

9. 867-290x22-M

10. 867-290x42-M

11. 869-180x22-M

12. 887-1601x2-M

13. 888-x601x2-M

14. 888-x60522-M

15. 888-3561x2-M

You can change the selection with the upper and lower buttons.

The actual selected class will be shown by flashing of the LEDs.

Example select class 281 – 140342-01:

Push 5 times the upper button.

The lower LED will flash 5 times and after this it has got a longer break. The cycle will be repeated

Example select class 887-1601x2-M:

Push 12 times the upper button.

Die obere LED blinkt einmal für die Zehn und die untere LED blinkt zweimal für die 2.

The upper LED will flash one time for the ten and the lower LED will flash 2 times for the 2 after this both LEDs have got

a longer break. The cycle will be repeated