Manualshelf

Technical information

ManualsBrandsDURKOPP ADLER ManualsMedia ConverterDAC basic
21222324252627282930
© 2012 Dürkopp Adler AG
Setting the basic functions
DACeco
22
7.1 Number of stitches during soft start
If the programming level of a parameter is selected, buttons S1 and S2 have the following functions:
Confirmation - Keep S1 (OK) pressed (> one second)
Cancellation - Keep S2 ( ESC) pressed (> one second)
Plus - Briefly press S1 (+) (< one second)
Minus - Briefly press S2 (-) (< one second)
Briefly pressing S1 increases the number of soft start stitches by one stitch; briefly pressing S2 reduces the
number by one stitch.
The set value is then indicated by the flashing LEDs.
S1 LED : 10s digit
S2 LED : 1s digit
The LEDs flash every 0.5 seconds. After a pause of 1.5 seconds, the sequence is repeated until it is confirmed
or cancelled.
Confirm the programmed result by pressing S1. Leave the programming level by pressing S2.
7.2 Speed
7.2.1 Set soft start speed
If the programming level of a parameter is selected, buttons S1 and S2 have the following functions:
Confirmation - Keep S1 (OK) pressed (> one second)
Cancellation - Keep S2 ( ESC) pressed (> one second)
Plus - Briefly press S1 (+) (< one second)
Minus - Briefly press S2 (-) (< one second)
Briefly pressing S1 increases the soft start speed by 100rpm; briefly pressing S2 reduces it by 100rpm.
The set value is then indicated by the flashing LEDs.
S1 LED : 100s digit
The LEDs flash every 0.5 seconds. After a pause of 1.5 seconds, the sequence is repeated until it is confirmed
or cancelled.
Confirm the programmed result by pressing S1. Leave the programming level by pressing S2.
7.2.2 Setting the maximum speed
If the programming level of a parameter is selected, buttons S1 and S2 have the following functions:
Confirmation - Keep S1 (OK) pressed (> one second)
Cancellation - Keep S2 ( ESC) pressed (> one second)
Plus - Briefly press S1 (+) (< one second)
Minus - Briefly press S2 (-) (< one second)
Briefly pressing S1 increases the maximum speed by 100rpm; briefly pressing S2 reduces it by 100rpm.
The set value is then indicated by the flashing LEDs.