Operation Manual

3.6.4 Inserting Material and Starting Automatic Operation

1. Turn the main switch on

2. Set the controls to sewing program 01

3. Operate the stop key to activate the program

4. Insert material

–

Operate the left pedal and hold in this position

–

Lay the material onto the two rear stops 1 and 2 and align centered

to the clamp

–

Release the pedal

5. If necessary, "intermediate air" the clamp for more precise

alignment of the material

–

Operate the left pedal and hold down

–

Align the material

–

Release the pedal

6. Start automatic operation

–

Operate the right foot switch

3.6.5 Extending the Duration of the Opening of the Clamp

The clamp is opened after the table turns and closed again after the

stacker sequence is completed. Thus, there is only a limited time

available for the feed procedure.

If the period is not sufficient for correct insertion, the duration of the

opening of the clamp can be extended by operating the left foot pedal.

If the clamp is opened too long, automatic operation is stopped.