Operation Manual

3.6.3 Changing the Size of Adjustable Material Holders

Caution Risk of Injury!

Before setting turn the main switch off.

1. Loosen the fastening

–

Loosen screws 3 and 4 with the special wrench 1

2. Set the size

–

Appropriately turn the adjustment screw 2 with the special

wrench 1.

The set value is shown on the scale 7.

When setting a smaller size, open the left half of the clamp 6 in

due time in order to bring the upward arched Delrin 5 back into the

required position again.

3. Tighten the fastening

–

Tighten screws 3 and 4 with the special wrench