Operation Manual

3.6.2 Changing Non-adjustable Material Holders

Caution Risk of Injury!

Before changing the material holders turn the main switch off.

1. Swing the sewing and trimming head out

–

Pull the magnetic roller shaft down and swing the heads out.

(See subject 3.7.1 and 3.7.2)

2. Remove the material holder

–

Loosen mounting screw 2 with wrench 1. Remove the material

holder

3. Screw the "new" material holders onto the turntable

–

When inserting take care that the two pins 3 and 4 touch below the

holder on the ring of the turntable.

–

Turn the leg of the wrench 1 so far toward the inside that a collision

with the sewing head is not possible

4. Swing the sewing and trimming head in

–

See Chapter 3.7.1 and 3.7.2