Operation Manual

3.6 Preparing, Starting and Interrupting Automatic Operation

3.6.1 Changing Adjustable Material Holders

Caution Risk of Injury!

Before changing the material holders turn the main switch off.

1. Set the material holder to the largest size.

–

With the special wrench 1 loosen the screws 3 and 4

–

Turn the adjustment screws 2 accordingly

2. Swing out the sewing and trimming heads

–

Pull down the magnetic roller shafts and swing the heads out

(See subject 3.7.1 and 3.7.2)

3. Remove the material holder

–

Loosen the mounting screws 6 on each holder with the special

wrench 1 and remove the material holder

4. Screw "new" material holders onto the turntable

–

The numbering 5 (1, 2, 3, 4 etc.) on the holders shows their

position on the turntable

5. Set the desired size

–

Turn adjustment screw 2 with the special wrench 1. See also

subject 3.6.3

6. Swing the sewing and trimming head in

–

See subject 3.7.1 and 3.7.2