Operation Manual

3.2 Threading Hook Thread

Caution Risk of Injury!

Before threading turn the main switch off.

–

Place the yarn spool on the yarn stand.

–

Alternatingly guide the thread through the guide eyes of the

take-off arm.

–

Feed the thread through thread tension 1 and thread guide 2.

–

Remove cover plate 3.

–

Lift the thread hold-down 4 out of its catch.

The spring 7 must be pressed to the rear.

–

Pull the thread through the holes 5 and 6.

–

Lay the thread in front of the wire of the hook thread monitor.

–

Pull the thread through the hook holes.

–

Close the thread hold-down.

–

Insert the cover plate.

3.3 Setting Thread Tensions

The thread tension of the needle thread should be higher than that of

the hook thread. Too high thread tensions cause the material to bunch.

Too low hook thread tensions can cause missing stitches.