Operation Manual

3.7.3 Tape Roll Holder. Changing the Feed Tape and Guiding It into the Unit

The tape roll holder of the 971 makes possible the working of sports

cuffs whose face cloth was previously basted to a feed tape with a cuff

basting unit and then wound onto a roll.

The basted cuffs are pulled off of the roll and separated with a

pneumatic scissors 8.

Caution Risk of Injury!

When changing the roll or feeding the tape do not touch key 2. Do not

reach into the area of the scissors.

–

Loosen screw 5 and pull off block 6.

–

Pull off the front tape roll plate 7.

–

Push in the catch and pull off the tape roll holder.

–

Push on a new roll with take-off device clockwise.

–

Push on the tape roll plate and secure with the mounting block.

–

Guide the tape to the right around roller 3 and to the left around

roller 4.

–

Pull the tape through behind the guide 1. With screw 2 set the

limiter block to the roll width.

–

Push the tape into the device 9.

–

Press the lever to the right and push the tape into the tape

scissors 8.

–

Push the tape so far that it can be pulled out unhindered from the

top.

1234675