Operation Manual

Set-up
Operating Instructions 971 Version 00.0 - 03/2014
43
6.5 Installing the reel stand
The setup and position of the reel stand can be seen in the main photo.
Note:
• Insert the reel stand and tighten the nut under the retaining plate.
• Reel stand holder and unwinding bracket must be above one another.
6.6 Aligning the sewing unit
Correctly align the sewing unit as follows:
1. Place the plates with rubber disks (in the accessory pack) under the four feet.
2. Adjust the height so that the cast iron body has sufficient clearance from
the ground; to do this, turn the four feet appropriately.
3. Place a spirit level on the frame and align the sewing unit using the four
feet. If a spirit level is not available, align the sewing unit such that the
swung out sewing head does not move from its position.
6.7 Connecting the stacker to the sewing unit
Fig. 26: Attaching the stacker
(1) - Clamping lever
(2) - Support plate
(3) - Fastening rail
(4) - Screws
཰
ཱི
ཱི
ི