Operation Manual

Set-up
42
Operating Instructions 971 Version 00.0 - 03/2014
To install the cutting head:
1. Install the cutting head as described in  6.2 Installing the sewing head
on the base machine, pg. 40.
When doing so, ensure that the distance between the guide piece (1)
and the plastic plate (2) of the clamps is 0.3-0.5 mm.
2. To correct, loosen screws (3) and (4) and turn the spindle (5) accordingly.
3. Guide the power supply cord of the motor through the frame (fastening)
to the control box.
4. The connections are labeled in the control box, see also wiring diagram
in  9 Appendix, pg. 51.
6.4 Installing the material holders
Fig. 25: Installing the material holders
Install the holder on the turntable ensuring the following:
• The numbering (2) (1, 2, 3, 4 etc.) on the holders indicates their
placement in the turntable.
• Tighten the fastening screws (1) with the special key (3).
(1) - Fastening screws
(2) - Numbering
(3) - Special key
཰ཱ ི