Operation Manual

Set-up
Operating Instructions 971 Version 00.0 - 03/2014
41
3. Turn the shaft (4) until the distance X is the same at the top and the
bottom. In this position, the distance between the throat plate insert (6)
and the plastic plate of the material holder should be 0.2 mm.
4. Tighten the upper and lower slotted nuts only so far that the bearing has
no play.
5. Secure the slotted nuts against twisting by turning down a lock washer lip.
6. Tighten clamping screws (2) and (3).
Connecting lines 1. Lay the power supply cord of the drive motor through the guide in the
frame to the control box.
2. Lay the line for the thread monitor in the arc to the swivel arm part (5)
and push through the elongated hole (5).
6.3 Installing the cutting head on the base machine
Fig. 24: Installing the cutting head
Caution: Risk of injury!
Install the cutting head with assistance or using
suitable tools, as appropriate.
WARNING
(1) - Guide piece
(2) - Plastic plate
(3) - Screw
(4) - Screw
(5) - Spindle