Operation Manual

Operation
32
Operating Instructions 971 Version 00.0 - 03/2014
Fig. 18: Swinging the sewing head in or out
Swinging the
sewing head out
To swing the sewing head out:
1. Bring the needle to the "upper position". For this purpose, turn the hand
wheel against the running direction until the needle is out of the material.
2. Pull the magnetic roller shaft (1) downwards completely.
3. Swing the sewing head out to the side.
4. Release the magnetic roller shaft.
Swinging the
sewing head in
To swing the sewing head in:
1. Pull the magnetic roller shaft (1) downwards completely.
2. Turn the throat plate insert (3) clockwise against the spring force.
3. Swing the sewing head into the turntable.
When doing so, ensure:
• that the side (2) of the throat plate insert (3) is pressed firmly against
the fabric support surface
• that the switching flag (4) is behind the magnetic roller.
4. Push the magnetic roller shaft (1) up.
(1) - Magnetic roller shaft
(2) - Side of the throat plate insert
(3) - Throat plate insert
(4) - Switching flag
཰
ཱི
ཱ
ི