Operation Manual

Operation
Operating Instructions 971 Version 00.0 - 03/2014
29
5.6.3 Inserting the sewing material and starting the automatic
sequence
Fig. 15: Inserting the sewing material
To start the automatic sequence:
1. Switch on the main switch (5).
2. Press the left foot pedal and hold in this position.
3. Place the sewing material at both rear end stops (1) and (2) and align
it centered to the clamp.
4. Release the left foot pedal (3).
5. It may be necessary to raise the clamp a little to align the material more
precisely.
6. Press and hold the left foot pedal (3).
7. Align the material.
8. Release the left foot pedal (3).
9. Start the automatic sequence by pressing the right foot pedal (4).
5.6.4 Extending the opening time of the clamp
The clamp is opened after the table is turned and closed again after the
stacker function is complete. Only a certain period of time is available
therefore for the feed process.
If there is not enough time to position the material correctly, the clamp's
opening time can be extended by pressing the left foot pedal.
If the clamp is opened for too long, the automatic sequence is stopped.
(1) - End stop
(2) - End stop
(3) - Foot pedal, left
(4) - Foot pedal, right
(5) - Main switch
཰
ཱཱི
ུ
ི