Operation Manual

Operation

Operating Instructions 971 Version 00.0 - 03/2014

7. Swing the sewing and cutting heads back in,  5.7.1 Swinging the

sewing head in and out, pg. 31,  5.7.2 Swinging the cutting head in

or out, pg. 33.

5.6.2 Changing the size of the adjustable material holders

Fig. 14: Changing the size of the material holders

To change the size of the adjustable material holders:

1. Release the lock by loosening screws (3) and (4) with the special key (1).

2. Adjust the size by turning the adjusting screw (2) using the special key (1)

accordingly.

The value set is displayed by the scale (7).

3. When setting a smaller size, open the left clamp half (6) in good time to

bring plastic plate (5), which is rounded upwards, back into the

prescribed position.

4. Secure the lock by tightening screws (3) and (4) with the special key (1).

Caution: Risk of injury!

Switch off the main switch before making settings.

WARNING

(1) - Special key

(2) - Adjusting screw

(3) - Screw

(4) - Screw

(5) - Plastic plate

(6) - Clamp halves

(7) - Scale