Operation Manual

Operation

Operating Instructions 971 Version 00.0 - 03/2014

5.6 Preparing, starting and interrupting the automatic sequence

5.6.1 Replacing the adjustable material holders

Fig. 13: Replacing material holders

To replace material holders:

1. Set the material holders to the largest size by loosening the screws (3)

and (4) with the special key (1).

2. Turn the adjusting screws (2) accordingly.

3. Swing out the sewing and cutting heads, by pulling the magnetic roller

shafts downward and swinging out the heads,  5.7.1 Swinging the

sewing head in and out, pg. 31,  5.7.2 Swinging the cutting head in

or out, pg. 33.

4. Loosen the fastening screws (6) on each material holder using the

special key (1) and remove the material holders.

5. Screw the new material holders to the turntable; the numbering (5) on the

holders indicates their placement on the turntable.

6. Set the desired size by turning the adjusting screw (2) using the special

key (1),  5.6.2 Changing the size of the adjustable material holders,

pg. 28.

Caution: Risk of injury!

Switch off the main switch before replacing

material holders.

WARNING

(1) - Special key

(2) - Adjusting screws

(3) - Screw

(4) - Screw

(5) - Numbering

(6) - Fastening screws