Operation Manual

Installation
96 Operating manual 969 - 00.0 - 08/2014
1. Remove the control unit (2)
2. Unscrew the cover (1).
3. Connect the cable as specified in the circuit diagram.
4. Screw on the cover (1).
7.7.3 Connecting control unit
Connect the control unit as follows:
• Insert the plug of each connecting cable into the sockets on
the back of the control unit.
The sockets for each connector plug are labeled with
pictograms.
• Connect the control unit to the power supply using the power
cable.
Important: Read the  Operating Manual for the eco/classic
DAC control unit.
The manual is included with the control unit.
The Operating Manual is also available in the document download
area at www.duerkopp-adler.com.
DANGER
Risk of death from electric shock.
Disconnect the power plug before connecting the
control unit.
Make sure the power plug is not accidentally
plugged back in.