Operation Manual

Installation
90 Operating manual 969 - 00.0 - 08/2014
2. Fasten the power cable mounting clamp (3) screws.
3. Fasten the cable clamps (5) with nails.
If the machine is equipped with a sewing lamp, first connect the
sewing lamp transformer to the control unit,  Connecting the
lighting, page 95. Then screw the control unit to the table plate
(the connection terminal is only accessible if the control unit is
removed).
7.5.3 Mounting the frame on the table plate and
mounting the pedal
Fig. 50: Mounting the frame on the table plate and mounting the pedal
1. Turn the table plate over so the underside is facing up.
2. Screw the left side plate (3) and the folding holder of the table
plate (2) to the plate so that the holes for fastening the machine
upper section (1) lie in the same axis as the holes in the table
plate.
(1) - Holes for fastening the machine
upper section to the frame
(2) - Table plate folding holder
(3) - Left side plate
(4) - Knee switch
(5) - Setpoint transducer
(6) - Pedal connecting rod
(7) - Foot switch
(8) - Pedal
①
②
④
⑤
③
⑥
⑦
⑧