Operation Manual

Operation
46 Operating manual 969 - 00.0 - 08/2014
5.10Raising presser foot with hand lever
The presser foot can be manually raised when setting up the
machine or to remove the material from under the presser foot in
an emergency if the compressed air supply has been disconnected
from the machine.
Fig. 23: Raising presser foot with hand lever
Raising presser foot:
1. Turn the hand lever from position (0) to position (1).
 Presser foot rises up to 14 mm above the needle plate and
remains raised. The machine can be run at idle while in this
position.
2. Turn the hand lever to position (2).
 Presser foot rises up to 20 mm above the needle plate and
remains raised.
CAUTION
Risk of crushing when lowering the sewing foot.
Make sure your hand is not underneath the presser
foot when it is lowered by the pedal or lever.
(0) - Hand lever at position 0
(1) - Hand lever at position 1
(2) - Hand lever at position 2
⓪
①
②