Operation Manual

Operation
44 Operating manual 969 - 00.0 - 08/2014
Standard operating mode: The presser foot always remains
lowered.
1. Turn off keys (13) and (14) on the OP1000 control panel (4),
 5.16 Operating the controller, page 63.
 Their signal diodes turn off – see  Operating manualfor
Basic/Classic DAC control panel.
2. Press the pedal (3) to position (-1).
 Presser foot rises.
3. Release the pedal to position (0).
 Presser foot lowers.
4. When a seam is complete, press the pedal to position (-2).
 The machine cuts the thread and the presser foot rises.
5. Release the pedal to position (0).
 Presser foot lowers.
Operating mode: After completing the seam, the presser
foot rises automatically.
1. Press the key on the OP1000 control panel (4) to raise the
presser foot after the thread is cut.
 Their signal diodes turn off – see  Operating manualfor
Basic/Classic DAC control panel. Presser foot rises.
2. Press the pedal (3) to position (+1).
 Presser foot lowers and machine starts up.
3. Release the pedal to position (0).
 Machine stops.
4. Press the pedal to position (-1).
 Presser foot rises.
5. Press the pedal to position (+1).
 Presser foot lowers and machine starts up.
ATTENTION
Avoid premature cutting of the thread before the seam is
finished through unintentional pressing of the pedal into
position -2.
Otherwise the seam will not be properly finished.