Operation Manual

Installation
Operating manual 969 - 00.0 - 08/2014 91
3. Screw on the foot switch (7) as close as possible to the left
side plate (3).
4. Screw on the pedal (8) as close as possible to the foot switch
(7). If the machine is equipped with a pedal then the middle of
the pedal must lie in the axis of the needle.
5. Screw the setpoint transducer (5) onto the holder.
6. Install the pedal connecting rod (6) and the move the pedal
ball pin holder so that the connecting rod lies in the axis of the
setpoint transducer (5).
7. Screw on the knee switch (4).