Operation Manual

Installation
88 Operating manual 969 - 00.0 - 08/2014
7.5 Assembling the special frame
7.5.1 Assembling frame components
Fig. 48: Assembling frame components
1. Screw both frame bar plates (13) to the rear bar plate (1) and
the front cross bar (9) and the lower left side plate (10) using
only the lower screws and screw these tight.
2. Screw on the head piece (14).
3. Screw on the rear cross bar (7) and screw in all screws in the
rear bar plate (1).
4. Screw on the plate holder hinge (5) including the folding table
plate holder (2).
(1) - Rear bar plate
(2) - Table plate folding holder
(3) - Upper left side plate
(4) - Holder for the setpoint trans-
ducer
(5) - Plate holder hinge
(6) - Oil can holder
(7) - Rear cross bar
(8) - Hinge for the left side plate
(9) - Front cross bar
(10)- Lower left side plate
(11)- Cross strut
(12)- Adjustment support
(13)- Side plates of the frame bar
(14)- Head piece
①
③
④
⑤
⑥
⑦
②
⑧
⑨
⑩
⑪
⑫
⑬
⑭