Operation Manual

Installation
Operating manual 969 - 00.0 - 08/2014 99
7.9 Lubrication
All rope and felt bits of the upper section are soaked in oil at the
factory.
Fig. 55: Oil level indicator
1. Fill oil through the filler hole (1) to a maximum of 2 mm below
the maximum level mark (2).
Required oil:
The machine should only be filled with DA 10 lubricating oil or
equivalent, with the following properties:
• Viscosity at 40 °C: 10 mm²/s
• Flash point: 150 °C
WARNING
Skin damage due to contact with oil.
Oil can cause a rash if it comes into contact with
skin.
Avoid any skin contact with the oil.
If oil gets on your skin, wash the affected areas
thoroughly.
MAX
MIN
(1) - Filler opening
(2) - Maximum level marking
(3) - Minimum level marking
①
②
③
ATTENTION
Machine damage possible due to incorrect oil level.
Too little or too much oil can damage the machine.
During initial filling, only pour in oil up to 2 mm below the
maximum level mark.