Operation Manual

Setup
92 Operating Manual 967 version 00.0 - 11/2013
7.12Sewing test
Conduct a sewing test before starting up the machine. Set the
machine to meet the requirements of the material being pro-
cessed.
To do this, read the appropriate chapter in this operating manual.
If the results of the sewing test do not meet requirements, read
the appropriate chapter in the  Service manual on how to make
changes to the machine settings.
Performing sewing test
1. Insert needle.
2. Wind hook thread on bobbin.
3. Insert bobbin.
4. Thread hook thread.
5. Thread needle thread.
6. Set thread tension to material being sewn.
7. Set thread limiter to material being sewn.
8. Set presser foot pressure to material being sewn.
9. Set presser foot stroke to material being sewn.
10. Set stitch length.
11. Transfer selected quick function from keypad to auxiliary
switch.
12. Start sewing test at low speed.
13. Gradually increase sewing speed until working speed is
reached.
Risk of injury from needle and moving parts.
Turn off the sewing machine before changing the
needle, threading thread, inserting the bobbin, set-
ting the hook thread tension or thread limiter.
WARNING