Operation Manual

Setup
90 Operating Manual 967 version 00.0 - 11/2013
7.11 Lubrication
All wicks and felt bits of the upper section are soaked in oil at the
factory.
Fig. 50: Oil level indicator
1. Pour oil through the filling point (1) at most up to 2 mm below
the maximum level mark (2).
Required oil:
The machine should only be filled with DA 10 or equivalent lubri-
cating oil with the following properties:
• Viscosity at 40° C: 10 mm²/s
• Flash point: 150 °C
Skin damage due to contact with oil.
Oil can cause a rash if it comes into contact with
skin.
Avoid skin contact with oil.
If oil gets on your skin, wash the affected areas thor-
oughly with water.
WARNING
MAX
MIN
(1) – Filling point
(2) – Maximum level mark
(3) – Minimum level mark
཰
ཱ
ི
Machine damage possible due to incorrect oil level.
Too little or too much oil can result in damages to the machine.
When first adding oil, fill up to no more than 2 mm below the
maximum level mark.
ATTENTION