Operation Manual

Setup
Operating Manual 967 version 00.0 - 11/2013 83
1. Fasten the rubber mounting bracket base (3) using screws.
2. Insert rubber bracket inlays (4).
3. Use screws (6) to attach the permanent tilt sensor magnet of
the upper machine section (5).
4. Remove the plug from the top of the upper machine section (2)
and screw in the suspension screw with eyelet (1) included in
the machine accessories.
5. Use a lifting device to mount the upper machine section (2)
into the cutout in the table plate so that it sits on the rubber
bases and inlays.
6. Remove the retaining clip (9) from the bolt (8), set the con-
necting rod (7) on the bolt and secure it with the retaining
clip (9).
Risk of crushing
The upper machine section is very heavy.
Make sure your hand does not get crushed while
mounting the upper machine section.
CAUTION
Risk of damage to upper machine section.
Once the upper machine section has been mounted onto the
machine, it cannot be allowed to tilt unless the connecting rod
is installed as described in Step 6. The upper machine section
could fall off the mounting bracket.
ATTENTION