Operation Manual

Setup
Operating Manual 967 version 00.0 - 11/2013 81
1. Loosen the adjustment screws (2) on the frame bars.
2. Set the table plate (1) to the desired height.
Important: Use a tape measure to make sure the table plate
is level.
3. Tighten the adjustment screws (2) on the frame bars.
4. Set pedal (3) so that the middle is directly in line with the needle,
 Assembling frame on table plate and assembling pedal,
p. 79.
5. Use the pedal connecting rod (4) couplings to set the angle as
desired by the machine operator.