Operation Manual
Setup
Operating Manual 967 version 00.0 - 11/2013 79
If the machine is equipped with a sewing lamp, first connect the
sewing lamp transformer to the control unit, Connecting sewing
lamp, p. 85. Then screw the control unit to the table plate
(the connection terminal is only accessible if the control unit
is removed).
7.5 Assembling frame on table plate and
assembling pedal
Fig. 43: Mounting frame and pedal
1. Screw the frame (2) down in the predrilled holes.
2. Screw the pedal (1) to the frame cross strut as close to the left
frame bar as possible.
3. Connect the lugs on the ends of the connecting rod (4) to the
ball pins on the sensor (3) and pedal (1).
4. Mount foot switch (5).
(1) – Pedal
(2) – Frame
(3) – Setpoint device
(4) – Pedal connecting rod
(5) – Foot switch
ཱ
ཱི
ུ
ི