Operation Manual

Operation
Operating Manual 967 version 00.0 - 11/2013 33
Manual needle positioning
Manual needle positioning is primarily intended for machine setup.
1. Raise the presser foot using the hand lever and remove any
material so the machine can run out.
2. Turn the handwheel (6) until the needle is correctly positioned.
Important: The correct direction of rotation is marked from
the back by an arrow on the belt cover (5).
Semi-automatic needle positioning
Works when the machine is on by using the electronic
handwheel (1) and is used to power the machine while the oper-
ating pedal (4) is released.
Turning the electronic handwheel drives the machine using the
motor's torque. This allows you, e.g., to sew a seam to the desired
position without the risk of going too far.
1. Press the power switch to turn the sewing machine on.
Important: The electronic handwheel is not immediately acti-
vated once the machine is turned on. Therefore:
2. Activate the electronic handwheel (1) either with a one-quarter
turn or by briefly pressing the operating pedal down.
3. Turn the electronic handwheel (1) until the needle is correctly
positioned.
Risk of injury from needle and moving parts.
Turn the machine off before manually positioning
the needle so the machine cannot accidentally start
while positioning.
WARNING