Operation Manual

Setting up
Operating manual 911 - Version 00.0 - 06/2013
97
10.4 Setting the working height
10.4.1 Frame with rollers
The working height is continuously adjustable between 800 and 1050 mm
(clearance between the floor and upper edge of the table plate).
Figure 63: Setting the working height on sewing units with rollers
1. Support the unit with a lifting carriage or forklift.
2. Loosen all 8 clamping screws (1) on the table legs.
3. Set the table plate level to the desired working height.
Important: Pull out or push in the frame tubes evenly at both sides to
prevent jamming.
4. Tighten all 8 clamping screws (1).
5. Remove the lifting carriage or forklift.
Risk of injury
The machine is heavy
Do not lift the sewing unit by the table plate. Always support
the unit using a lifting carriage or forklift before releasing the
clamping screws.
WARNING
(1) - Clamping screws
཰